When structural loads exceed what a standard shallow foundation can carry, deep foundations are designed to transfer the load using friction or end bearing resistance. Many factors, including structural loads, soil conditions, and access to the work area, should be considered when choosing the right deep foundation system for your project. Goettle specializes in the installation and design of various deep foundation systems, including drilled piers, augercast piles, micropiles and driven piles. Contact us today for assistance with choosing the right deep foundation system for your project.

Deep Foundations

Augercast piles are smaller diameter, cast-in-place deep foundation elements. They can vary in diameter from 12 to 48 inches and are most efficient in granular or incohesive soil and/or high water tables. Augercast piles can be installed quickly with minimal disturbance in noise and vibration. They can be designed as end-bearing, friction or a combination of both depending on the soil properties and proximity to rock.

Augercast piles are installed by rotating a hollow stem, continuous flight auger into the earth to the designed depth. Structural grout is then pumped through the hollow stem as the auger is slowly withdrawn. Once the hole is pumped full of grout, reinforcement can be placed.

Driven piles are a deep foundation element that is a pre-manufactured structural shape and can provide a wide range of capacities. There are a variety of driven pile types, including h-piles to pipe piles. Driven piles provide excellent quality control because they can be physically inspected prior to installation and during installation. Driven piles are installed using an impact or vibratory hammer.

Drilled Piers, also known as drilled shafts or caissons, are high capacity, cast-in-place deep foundation elements. They can vary in diameter from 24 to 144 inches and can be installed in a wide range of soil and rock conditions.

Drilled piers are installed by advancing ann auger / drill tool to the required depth usinng open hole, casing or slurry techniques. Once the desired tip elevation has been achieved, the drilled pier reinforcement is sent in place and the drilled shaft is filled with concrete.

Micropiles, also known as pin piles or minipiles, are small diameter, high capacity deep foundation elements. They can vary in diameter from 4 to 10 inches. Due to its minimal disturbance and small installation footprint they can be designed for both new construction and for existing structures.

Micropiles are installed by advancing a casing through the overburden material by flushing the cuttings with the aid of water or air. If applicable, once the casing has been advanced to rock, the designed rock socked is excavated utilizing a down-the-hole hammer. Once the excavation is complete, the reinforcing bar is placed and cement grout is pumped.

A drop shaft is an underground vertical or inclined passageway. Drop shafts are structured for a number of reasons, including the ventilation of a tunnel or underground structure, as a drop shaft for a sewage or a waste/service tunnel, or for access to a tunnel or underground structure, which can also be used as an escape route.

There are a number of methods for the construction of drop shafts, the most significant being the use of sheet piles, diaphragm walls or secant piles to construct a square or rectangular braced shaft. As well as the use of segmental lining installed by underpinning or caisson sunk to form a circular shaft. Shafts can be sunk either dry, or using a slurry method. When slurry drilling a shaft, the shaft is allowed to flood and the soil and debris are excavated out of the base of the shaft underwater.


Need A Quote?

(513) 825-8100

Questions, Pricing, More Information

© 2020 by Goettle